- Availability: In Stock
Digital soldering station with a Hairdryer EXtools (HandsKit) 852D is a versatile soldering equipment. Sufficiently high capacity in combination with fast and precise response to reach the set temperature allows to work with almost any material, in any industry. Besides, buy cheap the station not only the manufacturer, but in the retail networks of Ukraine.
Layout EXtools (HandsKit) 852D performed by the classical scheme, familiar to already have dealt with soldering stations masters. Wide temperature range will give the opportunity subtly to follow the technological requirements when working with completely different equipment and consumables such as solder. This is a significant plus for security and comfort in carrying out repair and Assembly work, soldering chips, etc.
The above features can be characterized by both soldering iron and hot air gun. First everything else has anti-static protection, which will not allow accidental static charges damage components over which the work is conducted. Soldering iron tips in the section accessories. The connection of the soldering iron with soldering station is a convenient and reliable connector. With a Hairdryer you may safely disconnect and connect again at the right time.
After working with EXtools (HandsKit) 852D front panel with controls and indication display leaves only positive emotions. There are all the controls:
- switch for soldering iron
- switch for dryer
- adjustable temperature soldering iron
- adjust the temperature of dryer
- controllable air flow
- connector soldering iron
Specifications EXtools (HandsKit) 852D:
- Voltage: 220V
- Output voltage: 26 V
- Operating temperature: 0 - 50 °C
- Storage temperature: - 20 - 80 °C
- Output power: 50 W
- Temperature range soldering iron: 200 - 480 °C
- The temperature of dryer: up to 450 °C
- Power airflow: 24 l/min
Equipment EXtools (HandsKit) 852D:
- Hot air soldering station
- Soldering iron
- Holder for hot air gun
- Stand for soldering iron
- 3 nozzles for hot air gun
ATTENTION ! Before first turning on the soldering station, remove the protective screw (M5X10 located on the lower surface of the station and marked with red color), which is installed by the manufacturer. This screw locks the compressor inside the station for safe transportation. The launch of the station with a transport screw may lead to mechanical damage of the soldering station. When damage to the plant in consequence of the failure of the specified conditions, the warranty is not valid.