Hot air soldering station EXtools (HandsKit) 850D

Hot air soldering station EXtools (HandsKit) 850D display- inexpensive and powerful equipment for repair and Assembly workshops. Metal housing protects the internal modules from mechanical damage and excessive vibration, temperature changes accurately and smoothly, digital display simplify the management. After the installation of the hot air gun in the stand, the magnetic sensor will shut off the heater and the dryer will begin to cool.

The front panel controls, namely:

• digital display;
• switch;
• the temperature controller of the dryer;
• the power control of the air flow.

The General impression from the soldering station EXtools (HandsKit) 850 are quite pleasant, despite its price. The build quality, the heating element is of excellent performance and reliability. Diaphragm pump dryer delivers powerful airflow evenly, facilitating operation in areas requiring particular accuracy (soldering bumpers, dismantling electronic parts). No soldering iron is narrows down the range of usage, but you can always buy a cheap soldering iron as an additional soldering equipment.

Specifications hot air SMD rework soldering station EXtools (HandsKit) 850D:

• Voltage: 110 / 220V
• Power consumption: 320 W
• Hot air gun power: 250 W
• The temperature of dryer: 100 - 480°C
• Control: microprocessor
• Pump type: diaphragm
• Air flow: 120 l/min (max)
• Heating element: nichrome spiral on ceramics
• Manufacturer: HandsKit
• Dimensions: 18.7 x 13.5 x 24.5 cm
• Weight: 4.2 kg

Equipment hot air soldering station EXtools (HandsKit) 850D:

• Soldering station EXtools (HandsKit) 850D
• Hot
• Holder under the dryer
• Power cable
• Nozzle for hot air gun (3 PCs)

ATTENTION ! Before first turning on the soldering station, remove the protective screw (M5X10 located on the lower surface of the station and marked with red color), which is installed by the manufacturer. This screw locks the compressor inside the station for safe transportation. The launch of the station with a transport screw may lead to mechanical damage of the soldering station. When damage to the plant in consequence of the failure of the specified conditions, the warranty is not valid.